Operating Instructions – Stark Lobster Tank
STARK Products Co., Inc.
Tel. (718) 445-5357
LOBSTER TANK
MODEL: SLS-175 CURVE
INSTALLATION
1) Floor drain, electrical and refrigeration stub-ups should be made compatible
with drawing prior to setting in place. Floor drain location is critical.
(Refrigeration stub-ups are for remote refrigeration).
2) Make certain that all light bulbs are set securely in their sockets as they can
potentially loosen during shipping and disconnect from the contacts. This
will cause arcing.
3) Connect all services.
4) Attach the bottom stainless steel skirts into the pre-tapped supports and seal
if required (see assembly instructions).
5) A Stark representative will set up the tank once electrical power and drains
are connected. Please call to confirm.
To Next Page
General