Volume up
Power on/off
Pair
Volume down
Pairing
The TV Streamer must be paired to interact with compatible 2.4 GHz hearing aids on the Thrive platform.
Pairing occurs once, then the hearing aids and TV Streamer will automatically recognize each other.
1
Power off your smart device or other accessories
that were previously paired with your hearing aids.
2
Ensure the TV Streamer is powered on.
3
Power off, then power on your hearing aids to
place in pairing mode.
4
Place your hearing aids within 6 inches
of the TV Streamer.
5
Press the pairing button on the TV
Streamer to place in pairing mode.
The LED will rapidly blink blue.
6
Once the LED blinks green
for each hearing aid, both
hearing aids are paired.
Basic Setup
5
TV Streamer
A B C D
Power Supply Jack (microUSB)
A
Toslink Jack
B
Analog 3.5mm Jack
C
Mono/Stereo Switch
D
1
Remove the plastic caps from each end of the
TOSLINK cable.
2
Plug the TOSLINK cable into the Audio OUT
jack of your television. If there is no TOSLINK
audio OUT jack, use a 3.5mm to RCA cable.
3
Power on your television.
4
Plug the other end of the TOSLINK cable
into the rear of the TV Streamer
B
.
5
Insert the power adapter microUSB connector
into the rear of the TV Streamer
A
.
6
Plug the power adapter into the wall socket.
7
Turn on the TV Streamer. A solid green LED
indicates power is on.
8
A solid blue LED indicates the TV Streamer
has detected audio and is streaming.
To Next Page
Need help?
General
