GL Machine Operation
Turn machine on at wall. Fit scrap tray, filter and shut door.
Press On/Off Key for 3 Seconds
Start key glows white as machine fills. If door is open then the start key glows
purple
Once full, rinse heating starts. Start key glows orange while heating.
Machine can be started when machine is heating. NOTE: If rinse temperature is
not sufficient cycle countdown will stop at 14 seconds. Washing continues until
rinse reaches temperature required for sanitization and
countdown then resumes.
Start key glows green when machine is fully heated. For different cycles press
the UP and DOWN arrows: Light, Medium, Heavy, Manual or Drain.
Close door/Press start key to start cycle. When manual cycle is selected
machine will continue washing until START button is pressed. Rinsing and
draining follow washing to complete cycle.
Start key glows red during cycle. Pressing Start key again terminates cycle
without rinse. Timer counts down to double zero and flashes 00 at cycle end
until door is opened.
SHUT DOWN - EVERY NIGHT
Press UP or DOWN keys to select Drain cycle and shut the door. Press START
key to start Drain cycle. Machine drains for 100 seconds with a cleaning rinse
mid-cycle. When Draining is complete machine goes into Standby mode.
Remove filter basket and scrap tray; rinse clean and replace.
DAILY CLEANING
The machine must be drained and cleaned at the end of each day.
Drain the machine as per the shut down instructions.
Remove, clean and replace filters.
Regularly check the wash and rinse jets and clean if necessary.
MAINTENANCE
Regular servicing of the dishwasher is essential for high
performance, efficient operation and long machine life.
Contact us for information on a maintenance programs.
Service 0800 782 754
Parts 09 829 0930
To Next Page
Loading...
