31
Black wire – connection to the ground (-). This
connection must be performed rst. For connection
it is recommended to use a regular bolt (screw) of
the ground. At the end of the wire, it is necessary to
crimp the terminal for the corresponding screw. Do
not connect the ground wire to the body with a self-
tapping screw.
Red wire – connection to the positive power source of
the car with 12 or 24 V. For connection it is necessary to
use regular wires of the car with section not less than
0,5 mm2 or to be connected directly to vehicle battery.
Blue wire – connection to the engine blocked
circuit. Cut one of the factory engine control circuits
and connect an additional blocking relay. The
blocking type – normally open (NO) or normally
closed (NC) can be congured in the StarLine Master
application. Normally closed blocking type is set by
default.
To Next Page
Loading...
