Need help?Do you have a question about the Starline XU and is the answer not in the manual?
Use qualified, skilled personnel for installation and follow instructions.
Read and understand operating instructions; train all staff. Not for children or infirm persons.
Some surfaces may be hot or very hot during operation.
Commercial detergents are hazardous; handle with care and use protective eyewear.
Wash water can exceed 60°C, rinse water 90°C. Door switches for emergency use.
Do not hose down machine. Watch for broken glass when cleaning inside.
Only qualified personnel should carry out service or repairs.
Damaged supply cords must be replaced by manufacturer or qualified person.
Unpack the machine, check for damage and complete delivery.
Place machine on a sound, self-draining floor and adjust feet to level.
Flush supply lines, connect to isolator valve with 20mm 3/4 male, 20L/min flow.
Connect to a 15A 230V 50Hz adjacent switched outlet.
Connect drain pump hose to upstand or sink waste connection.
Insert hose into commercial dishwasher low foam detergent container.
Insert hose into rinse fluid container; adjust injector as needed.
Run several cycles, ensure operator understands instructions.
Check water tap is open and supply pressure meets specification for filling issues.
Overview of power switch, gauges, and indicator lights for machine status.
Fit trays, filters, shut door, turn on switches. Power light glows red, then amber.
Load rack, shut door, press start. Cycle light glows green during operation.
Turn drain switch on, remove upstand, drain water, turn off switches, clean filters.
Pre-scraping dishes is recommended; cutlery should be pre-soaked in water.
Do not overload racks. Wash cutlery unsorted. Cycle times are short.
The XU has a 2-minute cycle.
Use correct type and quantity of detergent and rinse agent. Adjust concentrations.
Machine promotes fast drying. Remove rack promptly at end of cycle.
Drain and clean the machine daily. Remove, clean, and replace filters.
Weekly cleaning: Remove upstand, filter, trays, and wash/rinse arms for jet cleaning.
Regular servicing essential for high performance and long machine life. Contact for contracts.
To Next Page
General