1. Start by making sure your Starlink dish is set up and connected to the internet prior to setting up your Gen 3 Router.
2. Unbox your Gen 3 Router Kit.
3. Unplug your Gen 1 Router from the Gen 1 Power Supply, set aside.
It is not compatible as a mesh device and is not recommended as part of your Gen 3 Router setup.
support.starlink.com
Setup
GEN 3 ROUTER SETUP GUIDE (STANDARD GEN 1 KITS)
Gen 3 Router
Ethernet Cable
Gen 3 Router
Power Cable
Power
Supply
Starlink
Plug
RJ45
Cover
Gen 3 Router
1.5 m
(4.92 ft)
1.5 m
(4.92 ft)
4. Plug the Gen 3 Router into a power outlet using the power cable and power supply.
To Next Page
Loading...
