GB - 23
5.2 Automatic cleaning
Filter cleaning is performed (switch setting RA/switch ②a) auto-
matically during the next working break when the minimum volume
ow level is reached.
6 Emptying the container
NOTE
Only permitted for dust with AGW‘s > 1mg/m
3
Switch the vacuum cleaner off, pull the mains plug out.
▷ Open the latches.
▷ Remove the cover and suction hose from the container.
▷ Empty the container by pouring out.
6.1 Dispose of the eece lter bag
▷ Pull the mains plug out.
▷ Fit mouth protection.
▷ Remove suction hose, close off the suction spigot with a plug*.
▷ Open the side latches, remove the top section.
▷ Carefully pull the ange off the suction spigot and close off the
ange.
▷ Dispose of the vacuumed up material in accordance with legal
requirements.
6.2 Dispose of the PE emptying and disposal bag
▷ PE emptying and disposal bag: Switch the vacuum cleaner on,
shake the folding lter cassettes. Switch off the vacuum cleaner.
▷ Fit mouth protection.
▷ Remove suction hose, close off the suction spigot with a plug*.
▷ Open the side latches, remove the top section.
Before setting aside the top section, switch to >I< position, to
draw up any oating dust which may exist.
▷ Close off the PE emptying and disposal bag carefully with the
tape provided.
▷ Carefully pull the ange off the suction spigot and close it off
▷ Remove the PE emptying and disposal bag carefully from the
container
▷ Dispose of the vacuumed up material in accordance with legal
requirements.
6.3 Insert eece lter bag
NOTE
Only use eece lter bags for dry vacuum cleaning.
▷ Slide the ange completely over the suction aperture.
NOTE
Operating the rotary slider*
▶ Push the rotary slider* from the inside to the outside, turn
through 180° (see mark) and then push inwards again from
the outside through the suction spigot
▶ Place the rotary slider* in the suction aperture with the mark
▲ pointing upwards.
(* depending on the equipment variant)
▷ Place the upper section on the container and close the side
latches.
6.4 Insert PE emptying and disposal bag*
NOTE
Only the vacuum cleaners class M and H with special containers
and rotary slider in the suction aperture of types IS/ISC ARM,
IS/ISC ARH and IS/ISC ARH-ASBEST are suitable for the use of
PE Emptying and disposal bags.
NOTE
Operating the rotary slider*
▶ Push the rotary slider* from the inside to the outside, turn
through 180° (see mark) and then push inwards again from
the outside through the suction spigot
▶ Place the rotary slider* in the suction aperture with the mark ●
pointing upwards.
▷ Slide the ange completely over the suction aperture and place
the upper bag opening over the edge of the container.
▷ Place the upper section on the container and close the side
latches.
(* depending on the equipment variant)
To Next Page
Loading...
Need help?
General
