To Next PageTo Next PageWhat to do if dust accumulates in the container of my Starmix Vacuum Cleaner (M or H) with a filter bag?
If you notice dust accumulating in the container of your Starmix Vacuum Cleaner (dust classes M or H) even with the filter bag inserted, the rotary slide may be in the incorrect position. Set the rotary slide to the CLOSE position.
Why does my Starmix ISC L-1625 lose suction?
A drop in suction power in your Starmix Vacuum Cleaner can be caused by several factors: a dirty filter (clean it), a full filter bag (change it), a full container (empty it), a blocked motor protection filter (clean it), or a blockage in the nozzle, tube, or hose (clean these).
What to do if my Starmix Vacuum Cleaner does not start?
If your Starmix Vacuum Cleaner isn't starting, check the following: ensure the mains plug is properly inserted into the socket, verify the mains voltage by checking the fuse, and inspect the mains connection cable for any defects (replace if needed). Also, make sure the cover is properly closed, the water sensor is not switched off (empty the container), and the vacuum cleaner is not in standby mode. If it is in standby mode, set the switch to >I
Why Starmix ISC L-1625 doesn't start when tool is on >A< or >RA< mode?
If your Starmix Vacuum Cleaner doesn't start when the tool is switched on in >A< or >RA< mode, it could be due to the electrical tool not being plugged into the socket on the vacuum cleaner (plug it in). Another possible cause is a contaminated solenoid valve of the pneumatic on-off unit; if this is the case, rinse it with alcohol.
How to prevent the PE emptying and disposal bag from being sucked against the filter in my Starmix ISC L-1625?
To prevent the PE emptying and disposal bag from being sucked against the filter in your Starmix Vacuum Cleaner, ensure that the rotary slide is set to the OPEN position.
General| Voltage | 220-240 V |
|---|---|
| Frequency | 50/60 Hz |
| Cable length | 8 m |
| Power | 1600 W |
| Dust bag capacity | Not applicable |
| Hose length | 3.2 m |
| Container Volume | 25 liters |
Indicates when the container is full and/or there is a blockage in the suction hose.
For volume flow monitoring, to trigger an audible warning signal.
Adjusts the suction power with the speed control.
Checks and preparations before operating the vacuum cleaner.
Instructions for turning the vacuum cleaner on and off.
Guidelines for vacuuming dry dusts and suitable filter usage.
Safety precautions and procedures for vacuuming liquids.
Step-by-step guide for replacing folded filter cartridges.
Procedure for replacing or cleaning the motor protection filter.
Specific safety precautions for handling H and M class vacuum cleaners.
Guidelines for handling and disposing of contaminated parts.
Suitable for dry, non-combustible, hazardous dusts with OEL > 1 mg/m³.
