Starmix ISC L-1625 - Changing the Filter; Changing Folded Filter Cartridges; Changing Motor Protection Filter

26 - en
* depending on model
▶ Dispose of gathered material in accordance with legal require-
ments.
7.3 Insert eece lter bag
NOTE
Only use eece lter bags for dry vacuum cleaning.
▶ Slide the ange completely over the intake socket.
NOTE
Operating the rotary slide
▶ Turn the red rotary slide inside to position CLOSE to the stop
on the marker ▲.
7.4 Insert PE emptying and disposal bag*
NOTE
Only the vacuum cleaners class M and H with special containers
and rotary slider in the suction aperture of types IS/ISC ARM,
IS/ISC ARH and IS/ISC ARH-ASBEST are suitable for the use of
PE Emptying and disposal bags.
NOTE
Operating the rotary slide
▶ Turn the red rotary slide inside to position OPEN to the stop
on the marker ▲.
▶ Slide the ange completely over the intake socket.
▶ Place the upper bag opening over the container rim.
8 Changing the lter
8.1 Changing the folded lter cartridges
▶ Clean the lter cartridges before changing them.
▶ Turn the lock on the latch through 90° in a counter-clockwise
direction with a coin or similar object and push the latch to the
rear.
▶ Fold up the cover.
▶ Immediately isolate the folded lter cartridges that you have
removed in a dust-tight plastic bag and dispose of properly in
accordance with the requirements.
▶ Insert new folded lter cartridges.
▶ Lift the locking bracket up, fold down the cover and click in place
with light pressure.
9 Changing the motor protection lter
NOTE
If motor protection lter is contaminated, this indicates defective
lter cartridges.
▶ Replace folded lter cartridges.
▶ Replace motor protection lter or wash the motor protection
lter under owing water, dry and re-insert.
10 Transport
▶ Remove suction hose.
▶ Close off intake socket with cap.
▶ Securely x the motor head to the container.
▶ Close the side latches.
▶ Place the accessories in a suitable plastic bag and seal the plas-
tic bag or place it in the tool storage compartment.
▶ Put the suction hose ends together so that no dirt particles leak
out.
▶ Place the hose around the vacuum cleaner and clamp onto the
handle.
11 Maintenance
NOTE
Switch off the vacuum cleaner and pull out the mains plug before
carrying out any maintenance work.
For maintenance by the user, the vacuum cleaner must be
- dismantled,
- cleanded and
- maintained,
as far as possible without creating any danger to the maintenance
personnel or other.