REV A JAN/10 7
Support (35), close to the driven Wheel (25), can be manually adjusted by loosening
Knob (07), to set its distance relative to the material to be cut (figure 03).
2.2.2 Vise Assembly
The Vise Assembly (08) (figure 01A) is intended to securely clamp the
material to be cut to the Cutting Table (03) and forms the base of the machine,
made of injected aluminum alloy. Such assembly is comprised of:
- Cutting Table (03);
- Jaws (14);
- Tightening Spindle (29);
- Lever (04).
- Coupling Lock Lever (05).
2.2.3 Electrical System
An Electrical Panel (13A, 13B e 13C) is coupled to the Arc Assembly (10), as
shown in figure 01 A. This electrical system comprises a magnetic ON-OFF switch
that drives the machine (13A, 13B), and a mushroom-type emergency button (13C).
The machine operates on SINGLE PHASE 220V, at 50 or 60 Hz frequencies.
It allows for one single cutting speed, which changes according to the mains
frequency: 45 m/min under 50 Hz or 54m/min under 60 Hz.
To Next Page