Statesman FF2310APS - Fuse Replacement; Trouble Shooting

10
FUSE REPLACEMENT
(Moulded Plug Top – Class I)
Removethefusecoverwithasmallatheadscrewdriver.
Takeoutthefuseandreplacewithanewfuseofthe
sameAmp.Replacethefusecoverandpushbackinto
place.
Operating Sound
Thecoolinggaswhichcirculatesinthecoolingcircuitmaymakeaslightnoise(bubblingsound)
even when the compressor is not running. Do not worry this is quite normal.
Ifthesesoundsaredierentcheckthat:
• Theapplianceislevel.
• Nothingistouchingtherear.
• Thecontentsintheappliancearevibrating.
Changing the Bulb
TheinternalLightisLED;itisadvisedtocontactaqualiedtechniciantoreplacethebulb.
TROUBLESHOOTING
If you are having problems with your appliance, please use our troubleshooting guide below. If you
are unable to resolve the issue using this guide please ring our Customer Service Department on
0844 848 5861. Please have the model code and purchase information available.
Appliance does
notwork
Temperature control dial is
set at number “0”.
Mains plug is not plugged in
or is loose
Insert mains plug.
Fuse has blown or is defective Checkfuse,replaceifnecessary.
Socketisdefective Mains malfunctions are to be
corrected by an electrician.
Temperature is not properly
adjusted.
Doorwasopenforanextended
period.
Open the door only as long as
necessary.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Turn the temperature regulation
to a colder setting temporarily.
The appliance is near a heat
source.
Pleaselookinthe‘Installation’
section.
Set the dial to another number to
switch on the appliance.
Fault Possible cause Solution
The food is too
warm.
Pleaselookintheinitial
‘TemperatureSetting’section.