Solutions Strategies and Innovations
Static Solutions Inc. - Ohm - Stat RT - 1000 Information
ANSI/ESD-S20.20-1999
8. APPENDIX B- RELATED DOCUMENTS
The following documents are listed for further reference. Some documents may be canceled. However,
this listing provides a reference of documents reviewed during the preparation of this standard.
8.1. Military/U.S. Government:
FED-STD-101, "Federal Test Method Standard"
MIL-B-117, "Bags, Sleeves and Tubing--Interior Packaging"
MIL-PRF-81705, "Barrier Materials, Flexible, Electrostatic Free, Heat Sealable"
MIL-E-17555, "Electronic and Electrical Equipment, Accessories, and Provisioned Items (Repair
Parts): Packaging of"
MIL-HDBK-263, "Electrostatic Discharge Control Handbook for Protection of Electrical and
Electronic Parts, Assemblies, and Equipment (Excluding Electrically-Initiated Explosive Devices)"
MIL-M-38510, "General Specification for Military Microcircuits"
MIL-P-82646, "Plastic Film, Conductive, Heat Sealable, Flexible"
MIL-PRF-87893, “Workstations, Electrostatic Discharge (ESD) Control”
MIL-STD-129, "Marking for Shipment and Storage"
MIL-STD-1285, "Marking of Electrical and Electronic Parts"
MIL-STD-1686, "Electrostatic Discharge Control Program for Protection of Electrical and
Electronic Parts, Assemblies and Equipment (Excluding Electrically Initiated Explosive Devices)"
MMA-1985-79, Revision 3, “Standard Test Method for Evaluating Triboelectric Charge
Generation and Decay”
8.2. Industry Standards:
ANSI/IEEE-STD-142, "IEEE Green Book (IEEE Recommended Practice for Grounding of
Industrial and Commercial Power Systems)"
ANSI/EIA-625, "Requirements for Handling Electrostatic-Discharge-Sensitive (ESDS) Devices"
ANSI/EIA-541, “Packaging of Electronic Products for Shipment”
ANSI/EIA-583, “Packaging Material Standards for Moisture Sensitive Items”
ESD-ADV3.2, “Selection and Acceptance of Air Ionizers”
ESDSIL, "Reliability Analysis Center (RAC) ESD Sensitive Items List"
EIA-471, “Symbol and Label for Electrostatic Sensitive Devices”
IEC 61340-5-1, “Protection of Electronic Devices from Electrostatic Phenomena – General
Requirements”
EN 100015-1, “Basic Specification: Protection of Electrostatic Devices - Part 1 General
Requirements”
To Next Page
Loading...