5.1.1 VIEW SETPOINTS
The function of this mode is to provide a quick read-only access to the Alarm
setpoints. This operation is easier to do than to describe and is therefore shown
diagramatically below.
Pressing the CYCLE
key puts you into
VIEW SETPOINTS
MODE. The display
will show the first
setpoint number
available to be viewed,
possibly SEtP1.
Successive pressing of
the CYCLE key will
cycle through the other
available setpoints. If
any setpoint value is
required to be viewed,
the SHIFT key is
pressed. The actual
setpoint value is now
displayed.
The format of the setpoint display will be
<alarm action><Setpoint value>
where alarm action will be one of four single characters:-
o-Alarm Off; L-Low Alarm; h-High Alarm; d-Deviation Alarm
The Setpoint will be a five digit value scaled in engineering units.
USER OPERATION
Page 69
To Next Page
Loading...