4) ERROR CODES
Several error codes may appear due to the internal self checking of the instrument.
These indicate serious faults which cannot be rectified by the user. In the event of
these codes being displayed, the unit should be returned to the supplier.
The Error Codes are as follows:
Err 01 Non Volatile memory failure
Err 02 Ram decode error
Err 03 Ram size unrecognised
Err 04 Input card Error
Err 05 EPROM Checksum error
Err 06 RAM fault
Err 07 Calibration data corruption fault
APPENDIX C
Page 81
To Next Page
Loading...