stayer BC1200D - Specific Safety Instructions

ENGLISH
9
9
Thank you for purchasing a product STAYER!
Congratulations on your selection of a vacuum STAYER
ashes. We are condent that this tool will fully meet your
expectations. The ash aspirated models are designed to
clean the home, replace, barbecue, etc.. Also perfect to
eliminate sawdust particles and debris.
The tool is not intended for professional use.
WARNING! Read this manual and general
safety instructions carefully before using
the appliance, for your own safety. Your tool
should only be passed on together with these
instructions.
1. SPECIFIC SAFETY INSTRUCTIONS
Do not vacuum any sharp-edged, hot or incandescent
materials.
The appliance should not be exposed to heat. For use
with cold ashes only! (≤ 40°C).
Do not vacuum any moist or liquid substances. Never
immerse the appliance in water.
Unplug the appliance form the mains supply socket
after use and before every cleaning. Pull the plug, not
the mains cable, in order to disconnect the appliance from
the mains.
Do not put any object into openings. Do not use with
any opening blocked. Keep free of dust, lint, hair etc.
Do not use the vacuum cleaner without dust lter bag
in place.
Do not vacuum any our, cement etc, in order to avoid
the overloads.
The appliance should only be cleaned with a dry or
damp cloth; it should never immersed in water. Do not
use any solvents for cleaning.
This appliance is intended for domestic use only and
not for commercial applications.
Avoid contact with the nozzle ammable surfaces.
Do not use the mains wire to carry the appliance.
Always use the handle 6. Do not pull the mains wire over
sharp edges.
2. INSTRUCTIONS FOR USE
PLACEMENT TOOL
Packaging materials are not toys! Children
must not play with plastic bags! Danger of
su󰀨ocation!
If any parts are missing or damaged, please
contact your dealer.
ASSEMBLY
The machines are factory-installed, unless the suction
pipe 8, including in Cuba 1. Connect one end 10 of the
outlet tube 8 Cuba 1. Connect the other end of the pipe 8
to the metal suction roller 9.
Before use the ash vacuum, make sure all
connectors and the dust lter subassembly
(11 y 7) is tightly fastened. The container and
dust lter must be completely dry.
≤40°C!!! For use with cold ashes only! Do not
cover the lid tightly 9: Risk of burning engine.
ILUSTRATED DESCRIPTION
1 Container
2 Close the lid
3 Vacuum cap
4 Motor
5 Switch
6 Carrying handle
7 Disk lter
8 Flexible tube
9 Aluminium nozzle
10 Suction hole
11 Main lter
12 Notch closing lid
3. OPERATING INSTRUCTIONS
GENERAL INSTRUCTIONS
Unwind the power cord.
Connect the device and turn it on with the switch 5.
Unplug the appliance after use.
4. MAINTENANCE AND SERVICE
INSTRUCTIONS
CLEANING
- Remove the cover 3 by loosening the straps 2.
- Remove the lter 11 by pulling it.
- Remove the lter assistant 7 lifting a nger.
- Wash the lters with clean water and if necessary with
mild liquid detergent.
- Let dry the lters.
- Assemble the vacuum.
- Note that for the vacuum seal the closing lid 2 must
match the lid lock notches 12.
- You can also clean the lters with compressed air.
Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp
cloth is recommended. Water must never come
into contact
with the tool.