the camera will use the built in 32MB memory. If an SD card is
inserted into the slot then the camera will bypass the built in
memory and utilize the SD memory. The front counter display will
show the number of images on the built in memory unless the
expansion card is inserted at which point the counter will only
show the number of images in the expansion card.
Inserting SD card
Make sure camera is in the OFF position whenever adding or
removing memory.
• Insert SD memory card in to the SD card slot completely and in
the correct direction as shown by the sticker located at the side
of the housing.
• To remove the SD memory card, depress the SD card and pull
out the card gently.
SD cards must be clean (no images from other sources). If
you are using the SD card from other cameras, please
make sure to format the SD card prior use in the STC-
DVIR5 PROWLER. New cards are good to use straight
from the package.
To Next Page
Loading...
Need help?
General
