Set up and Programming
When the camera is first turned on, the internal LCD screen
displays the camera status. The following information is present
on this screen.
IR Emitter Mode Control:
The camera is pre-programmed with Auto IR Emitter setting.
Switch the camera to ON position.
To turn off the IR Emitter mode, press the [UP]
button once within 30 seconds. icon will
appear on the top of the screen.
To turn on the IR Emitter mode back to Auto setting, press the
[UP] button the second time. icon will appear on the top of
the screen.
If no buttons are pressed after 30 seconds, the LCD screen will power
down to conserve battery life, and enter 1 minute count down to enter PIR
detection mode. To re-power the display screen, press and hold the UP
or DOWN button until the status screen appears.
To Next Page
Loading...
Need help?
General
