"""#$%&'(%)*'+#*,+! -'.&!!!
/0012341/546!
*0!$50';5",50!!1/,'+'*4()"!'8*"/)9'
" TL DELAY – 00min 30sec (default): This setting is used to set a delay between TIME LAPSE images. This
setting can be changed between the numbers of 00min 05sec to 59min 59sec. With this option blinking, use of the
UP and DOWN arrows will allow the minutes setting to be changed from 00 to 59. Once this setting is
on the appropriate minutes, press the RIGHT arrow key to move to the seconds setting and it will start to
blink. Use of the UP and Down arrows will allow the seconds setting to be changed from 00 to 59 (05 to 59 if minutes
= 00). If the TL Delay is greater than or equal to 1 min, then the PIR sensor will be active
between time-lapse photos.
" TL START – 06:00PM (default): This setting is used to give the camera the start time for when to start the time* lapse
photography. The default format is in a HH/MM/AP setup, should the time format be in 24 hour the format it will
show HH/MM. With the HH (hour) setting blinking, use the UP and DOWN arrows to allow the setting to be changed
from 1 to 12. Once this setting is on the appropriate hour, press the RIGHT arrow key to move to the MM (minute)
setting and it will start to blink.Using the UP and DOWN arrows will allow the setting to be change from 00 to 59.
Again when this setting is on the appropriate minute, press the RIGHT arrow key to move to the AP (am/pm) setting
and it will start to blink. Using the UP and DOWN arrows will allow the setting to be changed from AM to PM.
" )%'()";'G'DB&DD0!!PS1;290WQB!%8=3!31WW=?X!=3!931S!W4!X=V1!W81!Z2<1:2!W81!3W4>!W=<1!;4:!581?!W4!1?S!W81!W=<1-
02>31!>84W4X:2>8\@!!%81!S1;290W!;4:<2W!=3!=?!2!ccO**O+.!31W9>T!38490S!W81!W=<1!;4:<2W!b1!=?!E6!849:!
W81!;4:<2W!5=00!b1!ccO**@!!a=W8!W81!cc!P849:Q!31WW=?X!W4!b0=?[=?XT!931!W81!'.!2?S!_)a#! 2::453! W4! 20045! W81!
31WW=?X! W4! b1! Z82?X1S! ;:4<! M! W4! ME@! ! )?Z1! W8=3! 31WW=?X! =3! 4?! W81 2>>:4>:=2W1!849:T!>:133!W81!&"Rc%! 2::45
To Next Page
Loading...
Need help?
General
