$TäAl.TH
Self-Cleaning
The cleaner can clean the roller brush and pipeline automatically on Self-Cleaning Base:
1). Please make sure there is enough clean water in the clean water tank , empty dirty water tank before
self-cleaning.
2). Place cleaner on the charging station(l), plug in the power supply well.
3).PresstheSelf-Cleaningbutton(2),theindicator@will bewhiteandflashslowly,andthecleanerwill
spray the clean water, clean the roller brush and pipeline automatically, meanwhile, it will vacuum the
dirty water into the dirty water tank.
4). Please unplug the power supply and clean the dirty water tank once the self-cleaning mode finished to
avoid getting stinky.
NOTE: The Self-Cleaning can only be applied when charging on the charging station.
O
(2)
Care and Maintenance
Please unplug the power supply, turn off the switch, and remove the battery pack out before care and
maintenance.
1. For daily care and maintenance, use a soft dry mop to wipe the main body, the charging station; use
a soft moist cloth to wipe the brush base, scraper, infrared sensor.
2. Roller Brush Cleaning
Release the lock button of the roller brush, rotate the brush counterclockWisé, then pull the brush out,
clean the brush, and brush guard with a cleaning tool.
www.altonindustries.com 12
To Next Page
Loading...