To Next PageTo Next Page
Need help?Do you have a question about the Stealth N7717 and is the answer not in the manual?
Turn off the main water supply before proceeding with installation.
Install new "T" bolts with brass washers and hex-head nuts for toilet bowl attachment.
Remove toilet from box, place upside down on a soft surface, and set wax ring in place.
Lower toilet bowl onto floor flange, align bolts, and tighten nuts carefully without overtightening.
Ensure the toilet bowl is level; use shims if it tilts or rocks.
Install plastic washer, metal washer, and hex nut; caulk base for finish and code compliance.
Place and secure the toilet tank onto the bowl with washers and nuts, avoiding overtightening.
Connect water supply to the fill valve and hand tighten, then connect to the shut-off valve.
Open shut-off valve, check for leaks, fill to water line, and adjust level with the float screw.
Install and adjust flush button mechanism rods for proper half and full flush operation.
Instructions for aligning and securing the toilet seat to the bowl, avoiding overtightening screws.
Addresses causes like blocked supply, low water level, or clogged trapway and their corrective actions.
Covers issues with high water level, debris in the valve, or a faulty seal, with corresponding fixes.
Warns against using toilet bowl cleaner tablets in the tank due to potential leakage and voided warranty.
Section for purchaser to fill out details for warranty registration.
Instructions on completing and returning the warranty card with proof of purchase for warranty to be effective.
General