Stealth P-7 - INSTALL THE HANDLEBARS

STEALTH ELECTRIC BIKES OWNER’S MANUAL
V 2.4 PAGE | 7
Torque Specifications:
Bolt
Torque (Nm)
Front axle
Check the manufactures specifications
Axle lockout
10
Rear axle nuts
45
Stem handlebar clamp
12.5
Stem steerer tube clamp
15
V-boxx cranks (B52 and H47 only)
60
Schlumpf speed drive bolts (F37
only)
50
Magura brake lever clamps
3
Side cover fasteners
7.5
1. INSTALL THE HANDLEBARS
The handlebars come from the factory with all controls installed and ready. Ensure that a torque wrench is used when
tightening bolts so that the correct torque value is reached.
I. Remove the 4 bolts around stem cap using a 6mm Allen key.
II. Remove cap from stem.
III. Gently and carefully cut tape securing forks to stem and remove bubble wrap.
IV. Install handlebars on stem making sure that wires and cables are moving freely and not fouled in any way.
V. Loosely reinstall the end cap on the stem using the same 4 bolts.
VI. Check alignment of handlebars and preferred riding position.
VII. Evenly tighten bolts to correct tension (see Torque Specifications table).