What to do if the screen is not turning on on my Stealth Bicycle?
If your Stealth Bicycle's screen isn't turning on, there are a few things to check. First, the BMS might need a reset; follow the BMS reset procedure. Also, inspect the key switch and connectors for any issues, checking for continuity. Finally, examine the screen and its connectors for any visible problems.
Why my Stealth Bicycle is switched on but won’t run?
If your Stealth Bicycle is switched on but not running, it could be due to loose or corroded connectors or wires. Visually inspect all wires for breakages or wear. Check all connectors beneath the battery pack, the large 3-pin connector to the motor, and the small 5-pin connector to the motor. It may also be caused by a damaged hall sensor, in which case you should refer to a dealer.
General| Brake Type | Hydraulic Disc Brakes |
|---|---|
| Category | E-Bike |
| Battery | 48V |
| Frame Material | Aluminum |
| Wheel Size | 26 inches |
| Top Speed | 50 km/h (31 mph) |
Register your bike online for full warranty support and important updates.
Guidelines for charging, handling, and storing the battery to ensure safety and performance.
Essential pre-ride checks including helmet use, local laws, and tire pressure.
Advice for riding off-road, respecting trails, property, and other users.
Recommended cleaning methods to avoid water damage and maintain bike components.
Recommendations for storing the bike and battery for extended periods to preserve performance.
Steps for initial assembly after unboxing, including handlebar installation.
Instructions for correctly installing the front wheel using the thru axle.
Guidance on installing pedals and crank assemblies for specific models.
Instructions for installing and adjusting the seat post for rider comfort.
Recommended tyre pressure and checks for wear and tear before riding.
Detailed procedure for charging the bike's battery for first use and ongoing.
Procedure for breaking in the battery during initial cycles to maximize lifespan.
Explanation of the throttle operation for regulating electrical power and speed.
Information on the hydraulic brake system, adjustment, and safe operation.
Guide to interpreting the Cycle Analyst display for power, battery, speed, and distance.
Guidance on checking and maintaining correct tyre pressure for performance and safety.
Instructions for checking, adjusting, and lubricating the bike's chain for proper operation.
Instructions for adjusting preload, rebound, and compression on the Bomber's rear shock.
Instructions for adjusting preload, rebound, and compression on the Fighter's rear shock.
Information on adjusting suspension forks, including RST R1 and White Brothers models.
Essential checks and maintenance tasks to perform after each ride.
Recommended monthly checks for tyre pressure, bearings, fasteners, and general condition.
Periodic maintenance tasks, including lubrication and grease replacement.
To Next Page
