STEALTH ELECTRIC BIKES 2013 OWNER’S MANUAL
V 1.2 PAGE | 25
SUSPENSION
Suspension is a key component of your Stealth Bike. Fork stanchions and preload adjustment should be checked periodically
and adjusted to suit the riders preferred setting. Always follow the manufacturer’s instructions for use and maintenance.
BOMBER
Rear Shock
Spring preload can be increased or decreased by adjusting the height of the lower spring collets using the C spanners
provided with the bike. The red rebound damping adjuster can be found at the bottom of the shock, and the compression
adjuster can be found on the top of the shock reservoir.
1. Unlock the preload adjustment by loosening the top lock ring on the spring unit using the supplied C spanner.
2. Rotate the spring and collet to increase or decrease the spring tension.
3. Re-lock the preload adjustment by turning the top lock ring clockwise until it locks against the spring retaining ring.
4. Tighten with C spanner.
5. Increase or decrease the rebound damping by turning the red rebound adjuster dial in the direction required (as
indicated on the bottom of the shock body).
6. Increase or decrease the compression damping by turning the black compression adjuster dial in the direction
required (as indicated on the top of the shock reservoir).
RST R1 forks - Refer to the RST Owner’s manual for more details.
Compression and rebound adjusters can be found at the top and bottom of the right hand fork leg respectively.
WARNING: This is a sealed unit and servicing should only be carried out by a qualified suspension repair person.
To Next Page
Loading...
