Steamfast SF-407 - Page 4

IMPORTANT SAFETY INSTRUCTIONS
4 Top Innovations
10. If Lighted On/Off Switch does not illuminate when power cord is plugged in and Switch is set to
“ON” position, unit is not operating normally. Immediately disconnect cord from power supply,
then refer to troubleshooting guide on Page 14 of this manual for assistance.
11. Always turn off unit and unplug power cord when not in use.
12. Do not use unit outdoors or operate where aerosol (spray) products are being used, or where
oxygen is being administered.
13. Unit is only meant to be used with recommended SF-407 accessories. Using other types of
attachments may cause damage to unit or injury.
14. When lling Water Tank, only distilled or de-mineralized water should be used in unit, in order
to minimize potential build-up of mineral deposits. Other cleaning agents could damage unit or
cause injury. Do not overll unit.
15. Do not attempt to use steam without properly lling Water Tank.
16. To reduce risk of contact with hot water emitting from steam vents, check appliance before each
use by holding Steam Nozzle away from body. Do not operate unit if steam vents are blocked.
17. Burns can occur from touching hot metal parts, hot water, or steam. Do not turn unit upside-
down – it may contain hot water.
18. When pressing/steaming any item for the rst time, it is recommended that you consult the
manufacturer’s guidelines for material being steamed. For items in question, test on an
inconspicuous area before proceeding.
19. Do not allow power cord to touch hot surfaces during use. Wrap cord loosely around unit when
storing.
20. Always allow Fabric Steamer to cool completely (at least 30 minutes) before storing.
SAVE THESE INSTRUCTIONS!
FOR HOUSEHOLD USE ONLY