4
|
ENGLISH
- Synthetic materials (such as 100% nylon or polyester) are sensitive to heat, and
may be damaged by exposure to hot steam. Steam is recommended for use only
on natural bers such as cotton, linen or wool, as well as nylon or polyester blends.
- Do not use unit where aerosol-based products are being used, or where oxygen is
being administered.
SERVICING WARNING – To reduce risk of re, electrical shock and injury to
persons, observe the following:
- If Lighted On/Off Switch does not illuminate when unit is plugged in and Switch is
set to “ON” position, unit is not operating normally. Immediately disconnect cord
from power supply, then refer to troubleshooting guide for assistance.
- Always allow unit to cool (30 minutes for complete cooling) and empty Water Tank
before storing.
- Clean your product regularly, only as is instructed in this manual. Prior to cleaning,
turn off the power on your product and unplug. Do not use gasoline, thinners,
solvents, ammonias or other chemicals for cleaning. Refer to the cleaning
instructions provided.
WARNING: Changes or modications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
READ AND SAVE THESE
INSTRUCTIONS
To Next Page
Loading...
