Steamfast SF-562 - Assembling Your Canister Fabric Steamer; Telescopic Pole Assembly; Connecting Telescopic Pole; Removing Telescopic Pole

ENGLISH
|
7
TELESCOPIC POLE
The Telescopic Pole is made up of three sections:
•
TOP (SECTION 1)
•
MIDDLE (SECTION 2)
•
BOTTOM (SECTION 3)
Sections 1 & 2 are adjustable in length. Section 3 is not adjustable.
By using the two extension locks, these sections may be extended
or retracted to achieve desired length. Refer to Adjusting Telescopic
Poles section below for more details.
CONNECTING TELESCOPIC POLE
Insert the thicker, green bottom side of the telescopic pole into the Pole Base on top of the unit.
REMOVE TELESCOPIC POLE
To remove telescoping pole from unit, grab the pole and pull upwards out of the Pole Base.
ADJUSTING TELESCOPIC POLE
1. Release extension lock directly below SECTION 1 by swinging hinge
outward. SECTION 1 can then be extended or retracted.
2. Once SECTION 1 is at desired length, close hinge to once again secure
extension lock.
3. Repeat Steps 1 & 2 for remaining hinges.
NOTE: It is recommended to extend Telescoping Pole to their full height
during steamer operation; this will ensure optimal steam ow through the
Hose.
SECTION 1
(TOP)
SECTION 2
(MIDDLE)
SECTION 3
(BOTTOM)
ASSEMBLING YOUR CANISTER FABRIC STEAMER