ENGLISH
|
7
CONNECTING HANGER
1. Release hinges on Hanger.
2. Align Hanger to Telescoping Poles with Nozzle Cradle
facing the front of the unit.
3. Insert both ends of the Hanger onto the poles and press
both ends simultaneously until the Hanger properly
engages (C).
4. Close hinges to secure the Hanger is locked onto
the poles.
CONNECTING STEAM HOSE
Connect the Steam Hose to the unit by pulling upward
on clamping ring on bottom of hose (D). While pulling
up, push onto steam outlet on unit (E). Release clamping
ring and push down into place.
CONNECTING FABRIC BRUSH
1. Make sure Steam Dial is turned to Off position, and that unit
is not emitting any steam.
CAUTION: Do not try to connect Fabric Brush while unit is
emitting steam, as this can cause burns and injury.
2. Align long pegs on back of Fabric Brush with corresponding
slots on face of Steam Nozzle (F).
3. Press Fabric Brush rmly onto Steam Nozzle until it ts snug
and rmly into place.
D
E
F
C
To Next Page
Loading...
