7
Cleaning
∙ The device must be cleaned after every use due to hygienic rea-
sons.
∙ Do not use aggressive or abrasive cleaning agents.
∙
The blades are very sharp! Risk of injury.
∙ Put the device in soapy water.
∙ Suck the soapy water with the plunger and spray it out again in
order to clean the injection needles.
∙ Then, remove the plunger completely and clean the cylinder.
∙ Carefully push the black injection needle guide back and forth
so that residues are removed.
∙ Dry all parts carefully before assembling and take cake that the
gasket will not get damaged.
Workplace
Important:
Never place this device on or next to hot surfaces (e.g. hot sto-
ves). Only use it on a even, stable and a heat resisting surface. It is
important that no inflammable items are near to the device. Do
not place the device on the edge of the table so that it cannot be
touched by children or fall down when touched.
To Next Page
Loading...
