16
∙ Never run the motor for more than 7 minutes, to avoid any
overheating. If the motor is overloaded for more than 10 se-
conds, the motor will switch off automatically. When this hap-
pens, please turn the switch to “0” position, plug out and then,
leave the motor to cool for about 3 min.
∙ If the device is blocked while juicing, turn the switch to 0 im-
mediately and then on “R” in order to eliminate the blockade.
∙ Be sure to check that the filter basket is always clean.
Cleaning:
∙ Turn the switch to 0 und unplug the device.
∙ Never immerse the motor part into water.
∙ Open the filling tube (no.5) with a rotary move.
∙ Clean the juice auger (no.4), the strainer (no.3), the strainer hol-
der (no.2) and the distributor (no.1) with washing up liquid and
leave to dry.
∙ Take care with the strainer in order to avoid damages on the
metal foil.
∙ Place the rubber pad (no.6) into the pulp ejection.
∙ Mount the device as described in section assembly.
To Next Page
Loading...