17
Assembly:
∙ The motor base should be wiped with
a damp cloth. All other parts can be
rinsed and dryed.
∙ A: Place the strainer (no.3) into the strai-
ner holder (no.2).
∙ B: Place the package from A into the
distributor (no.1). keep in mind that the
rubber pad must be placed above the
pulp ejection.
∙ C: Place the package from B onto the 3
pins on the motor part.
∙ D: Place the juice auger into package B.
∙ E: Mount the filling tube with a rotary
move.
∙ Then plug in the appliance.
Usuage:
∙ Move the on/off switch to „on“.
∙ When the device is being used for the first time, the motor may briefly generate a
slight odour.
∙ Always use washed, hygienic food.
∙ Put the food from which the juice is to be extracted into the filling funnel with the
motor running.
∙ Never put food with hard seeds or shells into the filling tunnel, the device might
get blocked and destroyed. Food must be cut to fit into the filling tube.
∙ Press the pusher slowly, without force down. Never use any other appliances or put
fingers into the feeding opening. Risk of injuries!
∙ After the last filling let the appliance work for some seconds, that the juice can
drop out of the spout.
∙ Do not overfill the pulp container, as this can cause problems during usage or even
demage the appliance.
∙ Never run the device without food or if overfilled.
To Next Page
Loading...
