Steel City 35620 User Manual (English)

Questions and Answers:

A
aguirrelukeAug 20, 2025
What to do if my Steel City Saw stops or won't start?
- C
  Carmen HallAug 20, 2025
  If your Steel City Saw stops or won't start, here are a few things to check: * First, the overload may have tripped. Allow the motor to cool, and then reset it by pushing the off switch. * Second, ensure the saw is properly plugged into the wall and the motor. Check all plug connections. * Third, a fuse might be blown, or the circuit breaker tripped. Replace the fuse or reset the circuit breaker. * Finally, inspect the cord for any damage and replace it if necessary.
T
timothyshannonAug 22, 2025
What to do if material kicked back from blade on Steel City 35620?
- D
  Daniel RobertsAug 22, 2025
  If material is kicked back from the blade of your Steel City Saw, consider the following: 1. The rip fence might be out of alignment. Align the rip fence with the miter slot. 2. The splitter might not be aligned with the blade. Align the splitter with the blade. 3. You might be feeding stock without a rip fence. Install and use the rip fence. 4. The splitter might not be in place. Install and use the splitter (with guard). 5. The blade might be dull. Replace the blade. 6. You might be letting go of the material before it is past the blade. Push the material all the way past the blade before releasing work. 7. The anti-kickback fingers might be dull. Replace or sharpen the anti-kickback fingers.
L
Lindsey AguilarAug 25, 2025
Why does my Steel City 35620 Saw makes unsatisfactory cuts?