Steel City 35903 User Manual (English)

Questions and Answers:

R
Raymond TrujilloAug 9, 2025
What to do if my Steel City 35903 stops or will not start?
- S
  Samantha SmithAug 9, 2025
  If your Steel City Saw stops or won't start, there are several potential causes. First, the overload may have tripped; allow the motor to cool and then reset it by pushing the reset switch. Ensure the saw is properly plugged into the wall or motor. Check all plug connections. Also, inspect the fuse or circuit breaker and replace the fuse or reset the circuit breaker if necessary. Finally, examine the cord for damage and replace it if damaged.
J
Joshua SteeleAug 14, 2025
Why is material kicking back from the blade on my Steel City 35903?
- C
  Cindy FullerAug 14, 2025
  Material kickback from the blade on your Steel City Saw can be dangerous. Here's what to check: * Ensure the rip fence is aligned with the miter slot. * Verify that the splitter is aligned with the blade. * Always install and use the rip fence when feeding stock. * Make sure the splitter (with guard) is properly installed and used. * Replace a dull blade. * Push material completely past the blade before releasing it. * Replace or sharpen dull anti-kickback fingers.
K
Kenneth SmithAug 19, 2025
How to fix inaccurate cuts on my Steel City Saw?
- G
  gdeanAug 19, 2025
  If your Steel City Saw isn't making accurate 45 or 90 degree cuts, or if material binds the blade when ripping, consider these points. The stops may not be adjusted correctly; check the blade with a square and adjust the stops. The angle pointer might not be set accurately; check the blade with a square and adjust the pointer. The miter gauge could be out of adjustment; adjust the miter gauge. Ensure the fence is aligned with the blade; check and adjust the fence. Warped wood can also cause this issue; select another piece of wood. An excessive feed rate can be a factor; reduce the feed rate. Lastly, the splitter may not be aligned with the blade; align the splitter with the blade.
J
johnthompsonAug 25, 2025
Why does my Steel City Saw make unsatisfactory cuts?