Steel City 35605 User Manual (English)

Questions and Answers:

F
Frank CantuAug 13, 2025
What to do if my Steel City Saw stops or will not start?
- J
  James JacobsonAug 13, 2025
  If your Steel City Saw stops or won't start, here's what you should check: * First, see if the overload tripped. If it did, let the motor cool down and then reset it by pushing the reset switch. * Make sure the saw is properly plugged into the wall and the motor. Check all plug connections. * Take a look at the fuse or circuit breaker. If a fuse is blown, replace it. If a circuit breaker tripped, reset it. * Inspect the cord for damage. If it's damaged, replace the cord.
J
Jason TownsendAug 17, 2025
Why does material bind blade when ripping with my Steel City Saw?
- F
  Frank LloydAug 17, 2025
  If the material binds the blade when ripping with your Steel City Saw, it could be due to several reasons: * The fence might not be aligned with the blade. Check and adjust the fence to ensure proper alignment. * The wood you're using might be warped. Try selecting another piece of wood that is straight. * You might be feeding the material too quickly. Reduce the feed rate to allow the blade to cut properly. * The splitter might not be aligned with the blade. Make sure to align the splitter correctly.
B
Brittney KingAug 21, 2025
Why does my Steel City Saw makes unsatisfactory cuts?
- C
  Colin SullivanAug 21, 2025
  If your Steel City Saw is making unsatisfactory cuts, consider the following: 1. The blade might be dull. Sharpen or replace the blade. 2. The blade might be mounted backward. Ensure the blade is properly mounted. 3. There might be gum or pitch on the blade. Remove the blade and clean it thoroughly. 4. You might be using the incorrect blade for the cut. Change to the correct blade type. 5. There might be gum or pitch on the table. Clean the table.