Need help?Do you have a question about the Steel City 35639 and is the answer not in the manual?
Information on available accessories for Steel City products.
Explains safety alert symbols and general warnings.
Warning about respiratory risks from dust and chemical exposure.
Mandate to wear safety goggles for eye injury prevention.
Requirement to wear appropriate hearing protection.
Guidelines for safe work areas and electrical connections.
Key rules for operating the machine safely and preventing accidents.
Emphasizes caution and adherence to safety practices for accident prevention.
Covers electrical codes, outdoor use prohibition, and wet conditions.
Rules for safe operation, including accessory use and cord handling.
Guidance on selecting and using appropriate extension cords.
Instructions for setting up the saw in its final location.
Procedure for removing the shipping brace from the motor.
Steps to install the motor cover onto the machine cabinet.
Instructions for attaching the table extension wings.
Steps for installing and securing the handwheels.
Procedures for aligning and installing the blade guard assembly.
Guide for safely mounting the saw blade onto the arbor.
How to check and adjust the blade guard for proper alignment.
Steps to ensure the table insert is flush with the saw table.
Instructions on how to use and adjust the miter gauge.
Explains how to adjust blade height and tilt angle.
Details about the thermally protected switch and reset procedure.
How to check if the blade is aligned with the table slots.
Procedure for checking and setting blade angle stops.
Checklist of essential inspections before operating the saw.
Steps for performing an initial test run of the machine.
Blade type for cutting with the grain, featuring fewer teeth and large gullets.
Blade type for cutting across the grain, with more teeth and shallow gullets.
Versatile blade for cuts with and across grain, balancing teeth count.
Blades designed to minimize material waste, often used with stabilizers.
Special blades for creating non-through cuts like dadoes and grooves.
Dangerous cutters for shaping wood, requiring specialized training.
Guide for lubricating worm gears and trunnions with white lithium grease.
Instructions for cleaning the saw's interior and exterior surfaces.
Steps for replacing the drive belts on the motor and arbor pulleys.
General| Brand | Steel City |
|---|---|
| Model | 35639 |
| Category | Saw |
| Language | English |
To Next Page
