steel K User Manual (English)

Questions and Answers:

R
Robert BeckerJul 29, 2025
Why is my Steel Ventilation Hood motor running but not extracting fumes?
- M
  mark42Jul 29, 2025
  If the motor of your Steel Ventilation Hood is running but not extracting cooking fumes, the metallic or active charcoal filters may be clogged. Try cleaning the metallic filters or replacing the active charcoal filters. Remember to disconnect the hood from the mains before accessing internal parts. Also, the duct might be clogged, so cleaning the duct is another possible solution.
T
Thomas ReeseAug 4, 2025
What to do if the steel K Ventilation Hood suction motor doesn't start?
- E
  emily70Aug 4, 2025
  If the suction motor of your Steel Ventilation Hood doesn't start when you press the on button, check if the plug is properly connected to the socket and that there isn't a mains failure. Also, verify that the electrical connector on the suction motor is securely attached. If it's disconnected, reattach it.
W
wvanceAug 9, 2025
Why won't the lights on my steel K turn on?
- M
  Melissa FritzAug 10, 2025
  If the suction motor of your Steel Ventilation Hood starts, but the lights don't turn on when you press the lights button, the bulbs may be blown and need replacing. Ensure the bulbs are fully inserted. If neither of these solutions work, the transformer may be faulty.
M
Michelle JamesAug 16, 2025
What does it mean when the timed switch-off button on my steel K Ventilation Hood is lit red?
- R
  Robert MoralesAug 16, 2025
  If the timed switch-off button on your Steel Ventilation Hood is lit with a red light when the motor is off, it means that the metallic filters need to be cleaned. This is normal after 30 hours of operation. To turn off the warning light, hold the button down for a few seconds.
J
Jennifer CarpenterAug 21, 2025
Why does my steel K Ventilation Hood turn off after a few minutes?
- K
  katelyn49Aug 22, 2025
  If the suction motor of your Steel Ventilation Hood stops suddenly after running for a few minutes, this is normal if the timed switch-off has been activated.