Europe EU Declaration of Conformity
Hereby, SteelSeries Apes. declares that the equipment which is compliance with directive RoHS 2.0 (2015/863/EU),
EMC Directive (2014/30/EU), and LVD (2014/35/EU) which are issued by the Commission of the European
Community. The full text of the EU declaration of conformity is available at the following internet address:
https://steelseries.com/ Operating Temperature: 0 to + 40 °C SteelSeries ApS. hereby confirms, to date, based on
the feedback from our suppliers indicates that our products shipping to the EU territory comply with REACH
(Registration, Evaluation, Authorization, and Restriction of Chemicals (EC) 1907/2006) compliance program. We are
fully committed to offering REACH compliance on the products and posting accurate REACH compliance status for
the all of products.
WEEE
This product must not be disposed of with your other household waste or treat them in compliance with the local
regulations or contact your local city office, your household waste disposal service or the shop where you purchased
the product.
Ukraine RoHS: , 3 2008 1057
This product is compliant with requirements of Vietnam Circular No. 30/2011/TTBCT Regulations “STIPULATING
TEMPORARILY THE PERMISSIBLE CONTENT LIMITATION OF SOME TOXIC CHEMICALS IN THE
ELECTRONIC, ELECTRICAL PRODUCTS” Restriction on Hazardous Substances statement (India) This product
complies with the “India E-waste Rule 2011” and prohibits use of lead, mercury, hexavalent chromium,
polybrominated biphenyls or polybrominated diphenyl ethers in concentrations exceeding 0.1 weight % and 0.01
weight % for cadmium, except for the exemptions set in Schedule 2 of the Rule.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Statement:
This device complies with RSS standards of the Industry Canada Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference