To Next PageTo Next Page
Need help?Do you have a question about the Steg Qx Mos 105.4x and is the answer not in the manual?
Properly fixing the amplifier to prevent damage to persons, the unit, or the vehicle.
Explanation of LED indicators (Green, Green+Red, Red) showing amplifier operational state.
Guidelines for connecting the positive power supply terminal, emphasizing adequate cable cross-section for performance.
Instructions for connecting the negative ground cable, stressing good contact quality for optimal performance.
How to connect the remote turn-on signal from the source unit to power the amplifier on and off.
Information on fuse location, value, and replacement procedures for safety and protection.
Connecting speakers for stereo operation, suitable for 2 or 4 Ohm impedance systems.
Connecting speakers for mono operation, requiring a system impedance of 4 Ohm or higher.
Using stereo outputs for mid-highs and mono for subwoofers, requiring minimum 4 Ohm impedance.
Proper connection of shielded RCA cables to gold-plated input jacks, avoiding signal interference.
Instructions to prevent contact between RCA connectors, maintaining GR.I.P.S. circuitry integrity.
Setting the input mode selector for single (1+2) or dual (1/2) RCA signal inputs.
Description of the internal two-way electronic crossover with separate controls for activation and frequency selection.
Instructions on how to enable the electronic crossover filters for selective frequency control.
Guide to inserting the optional AQXM2 module for precise frequency selection of the electronic crossover.
Amplifier operation with crossover controls in the OFF position for full frequency range output.
Steps to engage the electronic crossover filters for selective frequency control and system tuning.
Graphical representations of filter configurations: Off, On, Low-Pass only, and High-Pass only.
General| Brand | Steg |
|---|---|
| Model | Qx Mos 105.4x |
| Category | Car Amplifier |
| Language | English |
