Steinbach Speedclean Comfort 50 User Manual (English)

Other manuals for Steinbach Speedclean Comfort 50

Owner's Manual24 pages

Manual35 pages

Questions and Answers:

B
Bradley VanceAug 4, 2025
What to do if my Steinbach Swimming Pool Filter pump does not run?
- L
  luis60Aug 4, 2025
  If the Steinbach Swimming Pool Filter pump isn't running, start by checking if it's properly plugged into the socket and that the power cord is working. Also, check the G.F.C.I or main circuit breaker; if it has tripped, switch it back on. If it trips again immediately, it indicates a defect in the pump or its controls. If these steps don't solve the issue, the pump motor may be defective, and you might need to replace the entire pump.
M
Mackenzie EsparzaAug 8, 2025
How to fix high pressure on Steinbach Swimming Pool Filter?
- L
  lindsayjonesAug 8, 2025
  If the pressure gauge on your Steinbach Swimming Pool Filter reads over 1 bar, it's likely due to a dirty filter bed. To resolve this, backwash the filter by setting it to position 4.
J
Jeff WellsAug 13, 2025
Why is there sand in my pool from Steinbach Swimming Pool Filter?
- A
  Alyssa MartinezAug 13, 2025
  If you find sand in your pool after using the Steinbach Swimming Pool Filter, here's what you can do: * If the sand was recently replaced, backwash several times (position 4) until the backwash water becomes clear to remove any undersized grains. * If there's sand in the central valve (from backwash), purge it into the drainpipe for about 30 seconds (position 6). * Check the separation wall inside the filter to ensure it's correctly installed. * Inspect the filter bottom strainer for any damage and replace it if necessary.
C
cochranlindseyAug 17, 2025
What to do if the pressure is too low on my Steinbach Swimming Pool Filter?
- C
  Corey RobertsonAug 17, 2025
  If the pressure on your Steinbach Swimming Pool Filter is too low, it could be because the hair and lint strainer basket is dirty, or the pump isn't getting enough water. To fix this, clean the hair and lint strainer. Also, check the suction line and the water level to ensure the pump is adequately supplied.
K
Kathryn EstradaAug 21, 2025
How to get rid of air in Steinbach Swimming Pool Filter pump?
- A
  Amber BurchAug 21, 2025
  If there's air in the Steinbach Swimming Pool Filter pump, it's likely due to a poor seal on the intake side of the pump. Try tightening the hose clamps and connecting fittings to improve the seal.