Why is there a large error in the weight reading on my Steinberg SBS-KW-300AW?
A large error in weight readings on your Steinberg Scales can occur for several reasons: The scale may not have been zeroed before loading, in which case you should unload the scale and reboot it. It might need re-calibration, so try re-calibrating the scale. Finally, the unit might be incorrect, so switch to the correct unit.
What to do if my Steinberg SBS-KW-300AW readings are unstable?
Unstable readings on your Steinberg Scales can be due to several factors. The scale might be in motion, so stabilize both the load and the scale. Alternatively, the scale could be damp, so ensure you dry the scale. Lastly, dust on the PCB board can cause this issue, so clean the PCB board.
Why is the reading not zero on my Steinberg Scales without any load?
If your Steinberg Scales show a non-zero reading without any load, this could be due to: unstable system power, try allowing a longer warm-up time. Alternatively, the load-cell might be stressed too much or for too long, in which case you should hang the scale in storage.
What to do if no action is taken after pressing TARE or HOLD on Steinberg SBS-KW-300AW?
If pressing the TARE or HOLD buttons on your Steinberg Scales doesn't produce any action, it could be due to a defective TARE or HOLD key. Try cleaning the TARE or HOLD key.
How to fix a blank display on Steinberg Scales when the On/Off button is pressed?
A blank display on your Steinberg Scales when pressing the On/Off button usually indicates discharged batteries. Replace the batteries and then press the ON/OFF key for a long time.
To Next Page
General
