To Next PageTo Next Page
Need help?Do you have a question about the STEINEL PROFESSIONAL sensIQ KNX and is the answer not in the manual?
General| Type | Motion Detector |
|---|---|
| Technology | Passive infrared (PIR) |
| Detection Angle | 360° |
| IP rating | IP54 |
| Housing material | UV-resistant plastic |
| Version | KNX |
| Application, place | Outdoor and Indoor |
| Installation site | Wall and Ceiling |
| Detection Range | 20 meters |
| Reach, tangential | 20 meters |
| Supply Voltage | KNX bus |
| Current Consumption | 15 mA |
Product must be installed by a qualified electrician per national regulations.
Improper installation can cause serious injury or damage. Do not connect to 230V AC.
Unit uses pyro sensors to detect heat, converting it into signals to switch loads like lights.
Steps include switching off power, wiring, and connecting leads.
Involves undoing screws, detaching mounts, drilling holes, and marking positions.
Covers concealed and surface-mounted lead installation and cable entry.
Instructions for calibrating the product via ETS and programming button.
Details factory settings, reach adjustment, and shroud foil usage for detection zones.
Explains light-level, daylight, night-time settings, and time adjustments via remote.
Details on setting light-on time, 4-hour ON/OFF mode, and install/test mode.
Resets all settings to manual or factory defaults.
Instructions for recycling electrical and electronic equipment.
Guarantees product condition and proper working order for five years.
Procedure for submitting a product for warranty claims with proof of purchase.
