- 10 - - 11 -
1
2
3
4
8
9
Tool features
6
5
7
10
11
12
13
14
Enclosure
Hanger
Stroke adjustment
Glue stick guide
ON/OFF button
SET button (GlueMatic 7011 only)
UP button for increasing temperature
(GlueMatic 7011 only)
DOWN button for reducing temperature
(GlueMaitic 7011 only)
LCD information display
(GlueMatic 7011 only)
Power cord
Stand (removable)
Feed trigger
Exchangeable gluing nozzle
Nozzle cap
Important advice
L Do not use liquid or pasty adhesives.
L Nozzle and molten glue can reach temperatures of
over 200 degrees Celsius. Beware of burns!
L
You could burn yourself! After skin contact with
hot glue: immediately cool with cold water. Do not
try to remove hot-melt glue from the skin. If neces-
sary, seek medical attention.
L
After eye contact with hot-melt glue: immediately
cool for approx. 15 minutes with running water
and consult a doctor straight away.
L
The area you are gluing must be free of grease,
dry and absolutely clean.
L
Trouble-free operation can only be guaranteed
when using genuine STEINEL glue sticks.
L
Do not use in conjunction with highly flammable/
combustible materials.
L
Glue marks on clothing cannot be removed.
L Make sure heat-sensitive materials are suitable for
gluing with hot-melt adhesive.
L
Drips of glue are best removed when cold.
L Do not pull glue sticks out of the applicator.
Hot glue running into the applicator may cause
damage.
L
Optimum adhesion is achieved when the bond is
established instantly on applying the glue.
L
Unplug when not in use or during prolonged work
breaks (more than 30 min.).
L
Before inserting a new glue stick, wait a moment for
the cold cartridge to heat up. Never force the glue
stick through the applicator.
L
After changing nozzle, screw on hand-tight
(4.2Nm) using a tool, or the newly fitted nozzle
may not provide a tight seal, causing it to leak.
L
Once heated up, the applicator must be stood on
the stand.
It must not be laid on its side.
L
Unplug after use. Let the tool cool down com-
pletely before putting it away.
L
On leaving the factory, the tool is automatically set
to stay switched OFF when the power supply is
restored after a power cut.
Hot-melt glue applicator for use with genuine
STEINEL glue sticks. The tool must only be used
indoors in a dry and well-ventilated environment.
Proper use
GB
To Next Page
