- 12 - - 13 -
Explanations of the technical specifications on page 3
Nozzles
1. Long nozzle, 3 mm
Prod. No. 052737
2. Long nozzle, fine, 1.5 mm
Prod. No. 052928
3. Long nozzle, large, 4.5 mm
Prod. No. 052935
Glue sticks
1. General-purpose glue sticks, 300 mm, 600 g
Prod. No. 050092
2. Acrylate glue sticks, 300 mm, 600 g
Prod. No. 052416
3. Fast glue sticks, 300 mm, 600 g
Prod. No. 052430
4. Flex glue sticks, 300 mm, 600 g
Prod. No. 052423
5. Low Melt glue sticks, 300 mm, 600 g
Prod. No. 052409
6. MR Polyurethan (PUR) glue sticks 250, mm 200 g
Art.-Nr. 087388
Note:
Refer to data sheet with information on applying the
hot-melt adhesive. Data sheets and further information
are available at www.steinel-professional.de.
Your retailer keeps a stock of accessory nozzles.
Accessories
Display
Heating
element
Cause Remedy
"- - -" LOC function activated Deactivate LOC function.
(See "Other functions of GlueMatic 7011")
"Err" Warm Maximum temperature
exceeded
Let tool cool down.
Switch tool OFF and ON.
"Err" Cold Sensor short circuit
or sensor break
Replace heating chamber.
Please contact your service partner.
The LED on the GluePRO300 flashes rapidly to indi-
cate that a fault has occurred.
If the fault is indicated for more than 5 minutes,
please contact your service partner.
GlueMatic 7011 status indicators and error messages
GluePRO300 fault indication
L × W × H Dimensions Pmax Maximum output in watts
U Rated voltage in volts P
Ø** Rated input power in watts
T Temperature in °Celsius t
190 Heat-up time in minutes
m/t* Delivery rate per hour in kg m Weight without power cord in grams
* Depending on temperature and glue viscosity ** For 30 s of gluing / 60 s pause
GB
To Next Page
