- 16 -
English
HG 2220 E
1
7
8
6
9
5
4
3
8
2
4
Tool features HG 2220 E
Stainless steel outlet nozzle
Removable guard sleeve
Air inlet with integrated fine dust filter
Soft coating for non-slip standing
Heavy-duty rubber-insulated power cord
Multiple-stage switch for adjusting airflow
(2-stage)
Thumbwheel for setting temperature
Soft grip handle for comfortable operation
Replaceable mains power cord
1
2
3
4
5
6
7
8
Tool description - Operation HG 2220 E
Please note: The distance from the object you are working on depends on material and intended method
of working. Always try out the airflow and temperature on a test piece first. Using the attachable accessory
nozzles (see accessories page on the cover) the flow of hot air can be controlled with maximum precision.
Take care when changing hot nozzles! When using the hot air tool in the self-resting position, make sure it
is standing on a stable, non-slip and clean surface.
The tool is switched on and off by means of a two-stage airflow switch
6
. In settings 1 and 2, the tempera-
ture is continuously variable at a thumbwheel in 9steps. The guard sleeve can be removed.
Switching on causes brief voltage drops. If the mains power supply system is not absolutely stable, other
equipment may be affected. No disturbance is likely to occur with mains impedances of less than 0.43ohms.
9
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30
To Next Page
Loading...