- 19 -
English
Applications HG 2220 E
Shrink tubing on cables:
The shrink tubing is slipped over the section you want to insulate and heated with hot air. The tubing shrinks
by approx. 50% in diameter to give a sealed union. Shrinking is particularly fast and even using reflector noz-
zles.Sealing and stabilizing cable breaks, insulating soldered joints, gathering cable runs, sheathing terminal
blocks.
Forming PVC:
Sheeting, piping or ski boots can be softened and formed with hot air.
Soldering:
First, clean metal parts you want to join. Then, using hot air, heat the point you want to solder and offer up
the soldering wire. Use flux or a soldering wire with a flux core to prevent oxide forming.
Welding and joining plastic:
All parts being welded must be of the same plastic material. Use an appropriate welding rod.
Joining plastic sheeting:
The sheets are overlapped and welded together. A slit nozzle is used to direct hot air under the overlap, then
the two sheets are firmly pressed together with a feed roller.
Also possible: Repairing PVC tarpaulins by overlap welding with a slit nozzle.
Shaping:
Ski boots and sports shoes can be shaped for a perfect fit.
Welding sheeting:
The sheets are overlapped and welded together. A slit nozzle is used to direct hot air under the overlap, then
the two sheets are firmly pressed together with a feed roller.
Also possible: Repairing PVC tarpaulins by overlap welding with a slit nozzle.
- Welding all thermoplastics.
- Welding films and tarpaulins.
- Welding plastics and jointing.
- Activating and removing glues and hot-melt adhesives.
- Thawing frozen door locks, frozen water pipes, icy steps.
- Heating car-wrapping films.
- Applying edgebands.
- Shaping thermoplastics.
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30
To Next Page
Loading...