Steinway & Sons Model D – Installation Manual, version 2.1
The crate holds the tool for opening in the corner foot
During moving and handling, do not tilt the boxes more than 90 degrees. It might be best to unpack the system
outside the building in which the installation is to be made.
The crates have been assembled using the Clip-Lok packaging system. The clips must be removed with the tool
supplied inside the corner of the boxes as illustrated.
Pull out the Clip-Lok opening tool by using two fingers.
Place the tool behind the clip. Use your other hand to keep the clip in place when you unlock it. Otherwise the
clip may cause damage when it springs out of grip.
WARNING:
Be very careful when you unlock the clips. They are firmly fixed and may cause
damage when they spring open, unless you keep the clips in place with your free
hand as illustrated is active.
To Next Page
Loading...