Step 1: The material is as shown in the
figure: The white glue solidifies and stick
slowly.
Step 2: Connect the wires to the motor.
There is a small loop on each side where
you can thread the wire through, twist the
wire to secure
Step 3: Paste the wooden blocks on the wooden
strip. Make sure the holes are facing up and that
one is horizontal and one, vertical (as shown)
Encourage your children to build their robots and enjoy
the endless fun of DIY science activities. The gift is
recommended for kids 6 years and older.
Children can use motors, wires, and all the attached parts
to make electronic products with their own hands. Make learning
more interesting and fun while learning the basic principles of simple
circuits, motors, machinery, and engineering. Stimulate their curiosity
and creativity.
DIY instruction manual: a clear and complete scientific instruction manual
for children to learn, allowing your children to independently explore their
own world and exercise their ability to solve problems.
To Next Page
Loading...