Step 4: Glue the motor on
side of the vertical block and
the battery holder on the
side of the horizontal block
(as shown)
Step 5: Put the long shaft with
bushings on each side through
the vertical block. Add the angle
shafts to the motor
Step 6: Add the pullies
to the shafts
Step 7
: Add the rubber
band to the pullies
Step 8
: Twist the pipe cleaner
wire so you can add the eyes
Step 9
: Add glue to the double
sided tape to secure the eyes
Step 1
0: Fasten the
battery with cable ties to
make it more secure
PS
If your reptile robot is going
backward, change the wiring
on the motor.
To Previous Page
Loading...