The New Step
®
Touch Thermostat
The Ideal Way to Control Your Warmfloor
Installation &
Operation Manual
Do not use this equipment before reading this manual!
Model Number: EPI-LX-TC
Printed in the U.S.A.
Note: This manual contains important warnings
and instructions. Please read and retain
for reference.
© 01/2014 Step Warmfloor, Inc. All rights reserved.
The new Step Touch thermostat from Electro Plastics is
the elegant way to control your Step Warmoor system.
Perfectly suited and designed from the ground up
to work seamlessly with all Step Systems.
Features:
• Clean, simple two control design for ease of operation
• Three digit auto-dimmable LED Display
• Touch sensor controls that are maintenance free
• Clear, totally at acrylic surface for a clean contemporary look that works
well with any decor
• Elegant stainless steel perimeter housing
• Displays in Fahrenheit or Celsius
• Interfaces to an external temperature sensor
• Works with Step Warmoor, Step Snowmelt and Step Deicing systems
• Standard colors: black and white. Custom colors available at additional cost
• Capable of interfacing with smart home systems
• No batteries needed. All settings are stored in permanent memory for
instant recovery in the event of a power failure
• Step Warmoor logo is lit when system is heating
• Green friendly low power design
Specications:
Set Range: 40
º
to 90
º
F • 4
º
to 32
º
C
Internal Ambient Temp Range: 0
º
to 99
º
F, +/-1
º
F • -9
º
to 37
º
C, +/-0.5
º
C
External Sensor Temp Range: 0
º
to 99
º
F / -9
º
to 37
º
C
Power: 9-24 VAC/VDC @ <10mA (without external temperature sensor)
© 2014 Electro Plastics, Inc.
Need help?
General
To Next Page