Step2 RIDE ALONG SCOOTER

194722A01B07/14/2022
HELPFUL HINT:
Dip handle grips into a soapy water solution for easier assembly.
CLEANING INSTRUCTIONS:
Use a 50/50 mixture of vinegar and water.
WARNING:
BURN HAZARD
• Always check the temperature of the product before
letting your children play on it.
• Remember that the product may cause burns.
• Always be aware of the sun and weather conditions,
and do not assume that the equipment is safe
because the air temperature is not very high.
WARNING:
TO AVOID SERIOUS INJURY:
• Provide adult supervision at all time.
• Do not use in areas unsafe for pedestrians.
• Do not use on steps or steep inclines where product
could roll away.
• Keep away from pools or other bodies of water.
• Shoes must be worn during use.
• Allow a maximum of one riders.
• Periodically check the handle and hardware for wear
and proper assembly.
WARNING:
CHOKING HAZARD
Small parts. Sharp points. Adult assembly required.
USE FOR CHILDREN FROM AGES 1½ - 4.
OBSERVE ALL STATEMENTS AND WARNINGS TO REDUCE
THE LIKELIHOOD OF SERIOUS OR FATAL INJURY.
SAVE THIS SHEET FOR FUTURE REFERENCE.
DISPOSAL INSTRUCTIONS:
Please recycle when possible. Disposal must be in compliance with
all government regulations.
SAFETY INFORMATION
• Limit: 1 child. Maximum child weight: 40 lbs. (18.14kg.)
• Instruct children:
- not to use product until properly assembled.
- to keep hands, feet, loose clothing and long hair away from the
wheels during use.
• DO NOT remove any screws once installed. For disassembly, only
remove parts not secured by screws.
• DO NOT over-tighten screws or they will not hold parts together
appropriately.
• Take notice that screws are designed to pierce the plastic and form
their own threads.
INSPECT THIS PRODUCT BEFORE EACH USE. TIGHTLY
SECURE CONNECTIONS AND REPLACE DAMAGED OR
WORN COMPONENTS. CONTACT THE STEP2 COMPANY,
LLC. FOR REPLACEMENT PARTS.
The Step2 Company, LLC.
10010 Aurora-Hudson Rd.
Streetsboro, OH 44241 USA
1-800-347-8372 USA & Canada Only
(330)656-0440
www.step2.com
4207
RIDE ALONG SCOOTER
™
@THESTEP2COMPANY | #STEP2KIDS
www.step2.com/survey/?partnumber=420700
1

Step2 RIDE ALONG SCOOTER Specifications

General

Brand	Step2
Model	RIDE ALONG SCOOTER
Category	Scooter
Language	English

Summary

Safety and Warnings

Choking Hazard

Small parts and sharp points. Adult assembly required.

Burn Hazard

Check product temperature before use due to sun exposure.

General Safety Precautions

Adult supervision, safe areas, pool avoidance, shoes, one rider limit.

Cleaning Instructions

Use a 50/50 mixture of vinegar and water.

Disposal Instructions

Recycle when possible and comply with government regulations.

Assembly Steps

Step 1: Attaching Base Components

Attach part K to part B, repeating for the other side.

Step 2: Installing Support Rods

Install support rods (G) with caps (L, M) and repeat for two sets.

Step 3: Installing Handlebar Rods

Install handlebar rods (F) with caps (L, M) and repeat for two sets.

Step 4: Wheel Assembly

Assemble wheels (E, D) and attach to the main body (B).

Step 5: Securing Rear Wheels

Secure the rear wheel assemblies (M) to the main body (B).

Step 6: Attaching Steering Column

Connect steering column parts (CL, CR) and secure with caps (M).

Step 7: Connecting Handlebars

Attach handlebar grips (CL, CR) to the steering column.

Step 8: Final Handlebar Attachment

Secure the handlebar assembly to the main frame.

Step 9: Attaching Seat

Install the seat (A) onto the main body (B).

Step 10: Securing Seat

Use screws to firmly attach the seat.

Step 11: Applying Decals

Apply decorative decals to the assembled scooter.

Important Assembly Notes

Screw Installation Guidance

Product has no pre-drilled holes; screws form their own. Apply pressure.