38
3. Loop 1/8” Dacron rope (PN 21-7001-01) around each thimble as shown in Figure 2.18.
4. Secure each rope length together with two 1/8” Wire Clips (PN 60-0157). There should be about 3” be-
tween each clip as shown in Figure 2.19.
5. Repeat steps three and four
such that both turnbuckles have
a rope length attached as
shown in Figure 2.20.
6. Loosen turnbuckles by un-
screwing them such that they are fully extended as shown in Figure 2.20
and Fig- ure 2.21.
ELEMENT TRUSS SUPPORT (CONTINUED)
Figure 2.20
Figure 2.21
Figure 2.18 Figure 2.19
To Next Page
Loading...
